The Arduino DMX shield is an add-on (or "shield") for the Arduino. It is an easy way to use the Arduino as a DMX-Master device, just by adding the DMX-shield on the top of the Arduino.This DMX / RDM Shield is a low cost high quality solution that allows you to connect your Arduino driven artwork int..
In daily electronic projects, we may often encounter that the sensor cannot work normally, the project lags behind, and causes certain economic losses. This is caused by the incompatibility of the sensor level with the controller. In order to solve this problem, we have introduced a level conversion..
This Gold-plated process ATX Breakout Board can be used with ATX DC power supply and provides 3.3V, 5V, 12V and adjustable (ADJ) 1.5V-9.0V DC output voltage, the output maximum current is 2A.The ADJ adjustable voltage knob is also onboard, and the ADJ output voltage range is 1.5V-9.0V, which are ava..
This is a fan board used with Raspberry Pi 4th generation Raspberry Pi 4B to solve the problem of Raspberry Pi 4 generating a lot of heat when using Raspberry Pi 4B and its expansion board. , for all current boards with 40pin GPIO pins for Raspberry Pi (including pi 4/3B+/3B/2B/B+).The 40pin GPIO pi..
For beginners, Python programming is required when learning and making Raspberry Pi projects. We may often check the pin assignment table to find out the BCM code information and WiringPi code information corresponding to the relevant GPIO. This process is cumbersome and inefficient. In order to sol..
Remember the candlelight from childhood? In the warm light, your shadow of high and low swayed on the wall of the house...full of childhood memories. pzsmocn recently launched a warm-color LED light strip, imitating childhood candlelight. With the power on, the room can be filled with lights of vari..
This product uses high-quality and high-brightness WS2812 full-color LED driver chip. Support multi-module cascade, more than 100 modules can be cascaded with only one signal pin, with a total length of tens of meters, which can meet the needs of different application scenarios and has an excellent ..
This is an ordinary LED RGB color-changing lamp bead module, using F5 atomized full-color RGB common cathode LED as components. When using, only need to connect the RGB module to the PWM port of the microcontroller, and connect "-" to GND.This product has built-in red, green, and blue lights, and th..
TF (Micro-SD) card is the most commonly used storage element for interactive media devices. The pzsmocn TF (Micro-SD) card read-write module adopts SDIO/SPI communication mode, which can be used to read or write data to the TF (Micro-SD) card.When using, we only need to insert the TF (Micro-SD) card..
Ocean: MCP23017 IO Expansion Board expands 2 signal pins as 16 I/O pins based on the I2C bus, up to 8 MCP23017 IO Expansion Board can be used at the same time, providing up to 128 I/O pins, it is compatible with both 3.3V and 5V levels.Wiki: http://www.cqrobot.wiki/index.php/MCP23017_IO_Expansi..
CQRobot ADS1115 16-bit ADC module can accurately collect and convert analog signals. Through this ADC module, Raspberry Pi can easily use a wide range of Arduino series analog sensors to measure various signals, and perceive this world. Raspberry Pi is a common master control board which is powerful..
The X715 is a power management expansion board for Works with all current models of the Raspberry Pi using a 40 pin header,with other Raspberry Pi accessory boards for enhanced applications.Fully compatible with X820 X850 X860 X870 X822 X852 X825 X828 X856. It provides Max 5A of continuous outp..