Atomization Sensor with Housing

This is an ultrasonic atomization drive module that supports Arduino programming control and is designed for constant humidity adjustment and delicate spray scenes.

This atomizing humidifier is equipped with a programmable ultrasonic atomization driver module, which supports precise adjustment of constant humidity and fine water mist output through Arduino programming. Low noise operation, convenient touch operation. Compatible with Lego hole structure, ensuring stable power supply and flexible expansion. The atomization module consists of a driving module and atomization blades, mainly used to atomize and humidify water. It can be controlled by a microcontroller or manually operated with buttons. V is connected to a 3-5V voltage input, G is connected to GND, and S is the signal pin.

be careful:

1. After turning on the switch, the atomizer should be placed in water. If left in the air for a long time, the atomizer will become hot and burn out.

2. Place the atomizer gently on the water surface. If the entire atomizer is placed in water, it will prevent the atomizer from successfully generating water mist.

Suitable for bedroom humidification, office environment humidity regulation, and LEGO creative integration projects.

SPECIFICATION

• Interface: 3PIN 2.54mm bent pin (control end)
• Model: Atomization Sensor
• Size: 34 * 26 * 16mm
• Working Voltage: 3.3V/5V
• Atomizer Interface: PH2.0 female end
• Installation Hole: aperture 4.8mm, hole spacing 16mm
• Temperature Resistance: -25 ° C~+60 ° C
• Installation Method: through-hole surface encapsulation

DISTRIBUTION LIST

1 * Atomization Sensor

1 * Atomization Sheet and Bracket

1 * XH2.54-3Pin to Female Single-row DuPont Cable, 19.5cm Long